Help with Setup, MODEM > WRT54G > RT31P2

Posts: 8 · New Forum Member Joined: Apr 04, 2005 Posts: 8

I can't find a FAQ on this question so any help would be appreciated.
Here is my current setup

RT31P2:
WAN Cable going to LAN port on WRT54G
Set to Static IP on WAN to an ip on my local network. ie. 192.168.50.6

WRT54G:
Existing router I had, no changes made.

My voice status page shows Online, and idle for the ports, but when I pick up the phone, I get nothing..

What am I missing here?

Posts: 3198 · Posted: Mon Apr 04, 2005 2:23 pm Post subject:

does it have your phone number after registration status (above "idle")? phone lights on or off?

Posts: 8 · New Forum Member Joined: Apr 04, 2005 Posts: 8

Phone Light for Port 1 is on

I have a phone # in the status page.

Voice Version: 2.0.13(LIVd)
Customization: Customized

--------------------------------------------------------------------------------

Line1 Status

Registration Status: xxx-xxx-xxxx 1 xxxxxxxxxx Online
Call1 Status: Idle
Call2 Status: Idle

--------------------------------------------------------------------------------

Line2 Status

Registration Status: Offline
Call1 Status: Idle
Call2 Status: Idle

Posts: 8 · New Forum Member Joined: Apr 04, 2005 Posts: 8

Do I need to forward any ports?

All I hear when I pick up the phone is a halo sound as it sounds when a normal line is dead.

Tested the phone + cable on a normal jack and it worked fine.

Posts: 3198 · Posted: Mon Apr 04, 2005 2:31 pm Post subject:

are you sure it's plugged into the right port? they're opposite of the lights so try both.
I doubt you need to forward ports, but if you want to try it real quick, just put the rt31p2 ip in the dmz of the wrt.

Posts: 8 · New Forum Member Joined: Apr 04, 2005 Posts: 8

Yep! that was it, the lights got me ...

I had it in the wrong port :-/

THANKS!

Do I need any port forwarding? I have it setup for 10000-20000 and 5060-5061 but am not sure if I need that.

Posts: 3198 · Posted: Mon Apr 04, 2005 4:06 pm Post subject:

most likely no.