Linksys PAP2 now working: power LED constantly blinking

Posts: 1 · New Forum Member Joined: Mar 06, 2009 Posts: 1

I had to shift my phone from my one office to other and when I connected powered on my PAP2 in my new office , the Power LED kept blinking, however my ethernet LED is Solid and my phone 1 LED is not on at all.
I tried step by step instructions: http://www.vonage.com/support.php?article=488&category=3&nav=3
but it didnt help.
Couldn't make out much from following either:-
___________________________________________
Red on = POST failure or device malfunction.
Blue Blinking = Booting / Self Test / Firmware Upgrade
Status and Link LED Blink Patterns
LED Color(s) Activity Description
Power LED
Blue/Red Off Power Off
Blue On Power On / Device Ready
Blue Blink Booting / System Self-Test / Firmware Upgrade
Red On Power On Self Test Failure (not bootable) / Device Malfunction
Ethernet Blue Off No Connection On Ethernet
Blue On Ethernet Connection Established
Blue Blink Data Sending / Receiving
Phone 1 /
Phone 2 Blue Off Phone Is Not In Use / Not Provisioned or Registered
Blue On Registered / Provisioned
Blue Blink Phone Is In Use / Incoming Call Detected
___________________________________________

What do you think the problem is? Has my PAP2 been shorted ? is there anything I could do on my side without resending the device or contacting the tech support. Any pointers would be of great help..

Posts: 628 · Posted: Fri Mar 06, 2009 6:44 am Post subject:

Most likely this is caused by an IP address issue. This means that you are either not getting an IP address or you previous placed a static IP on the PAP2 and now your connecting it to something that has a different network then the previous.

1) What did you plug the PAP2 into in the old office?

2) What are you plugging the PAP2 into at the new office?