| Author |
Message |
VonTechMgr
Vonage Forum Evangelist


Joined: Jan 02, 2008
Posts: 656
Location: NJ
|
|
|
|
 |
Jkirven
New Forum Member


Joined: Jan 08, 2009
Posts: 9
|
alright, I did that, the page is still comming up blank. |
|
|
|
|
 |
VonTechMgr
Vonage Forum Evangelist


Joined: Jan 02, 2008
Posts: 656
Location: NJ
|
Only suggestion I can make at this point is to download and install firefox which is much better the Internet Explorer and is a free web browser. Once installed, try to access the virtual server page from Firefox. |
|
|
|
|
 |
Jkirven
New Forum Member


Joined: Jan 08, 2009
Posts: 9
|
|
|
|
 |
Jkirven
New Forum Member


Joined: Jan 08, 2009
Posts: 9
|
Page still came out blank. |
|
|
|
|
 |
Slyster
Vonage Forum Senior


Joined: Sep 26, 2008
Posts: 81
|
|
|
|
 |
GSport
New Forum Member


Joined: Feb 09, 2009
Posts: 5
|
I have the same problem (page loads blank...defect in the software that can only be fixed by a new firmware)
Yeah, a similar write-up buried in another thread helps fill in the knowledge gap: I think I have read on different threads over here the problem faced when you are trying to do port forwarding on DLink VWR device. Port Fwding is especially required if you using any torrent clients.
A solution has been given at http://www.portforward.com/english/routers/port_forwarding/Dlink/VWR-11.4.0/Utorrent.htm but the problem is when you click on 'New' to add a rule to User category, it gives a blank page.
Solution is instead to click on 'Custom Port Forwarding' [http://192.168.15.1 (username n passwd both are 'user') > Advanced > Virtual Server (on left side frame)] and then putting in the following details: - Enable: Select it - Application: Name of application such as utorrent, etc - Protocol: TCP & UDP (for safety sake rather than just one of them) - Source IP Address: 0.0.0.0 - Source NetMask: 0.0.0.0 - Destination IP Address: Your laptop/desktop's static ip add - Destination Netmask: 255.255.255.255 - Destination Port Start: 80 - Destination Port End: 80 - Destination Port Map: 80
Also change the port on your application (such as utorrent to 80). This should do the trick.
Good luck |
|
|
|
|
 |
rukus
New Forum Member


Joined: Sep 11, 2007
Posts: 4
|
I have gone through the virtual server/user/new/etc but when done my fileshare pro only shows the local router ip and not my internet ip. Color me confused. Am I putting in some wrong numbers??? Vonage is useless with info. |
|
|
|
|
 |
|
|
| Goto page Previous 1, 2
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum |
All times are GMT - 5 Hours | |