Dlink DIR-655

Posts: 3 · New Forum Member Joined: Feb 13, 2007 Posts: 3

I have a dlink dir-655 router with the linksys PAP2v2. What type of QOS should I set. I little confused on how to set this up on the router.

Posts: 1178 · Member of the Week Joined: Feb 28, 2005 Posts: 1178

here is a faq from the dlink support about that question exactly:

http://support.dlink.com/faq/view.asp?prod_id=2485&question=DIR-625%20/%20DIR-635%20/%20DIR-655

Maybe this will help.

Posts: 3 · New Forum Member Joined: Feb 13, 2007 Posts: 3

Thank You! I know the local ip range is the adapters ip address but what should the local port range be? Also, correct me if I am wrong but the protocol should be udp correct?

Posts: 1178 · Member of the Week Joined: Feb 28, 2005 Posts: 1178

you do want to make sure that your vonage router is set to static ip. then you want to go here for the ports:

http://vonage.com/help.php?article=1098&category=44&nav=3

It looks like both udp and rtp see below:

Ports used by Vonage Adapters

The following ports are needed for OUTGOING Internet communications from the Vonage device to the Vonage servers.

DNS: Port 53 UDP

TFTP: Port 21, 69, 2400 UDP

HTTP: Port 80 UDP

NTP: Port 123 UDP

SIP: Port 5061 UDP (used for older Vonage devices provisioned before 2005)

The following ports are needed for INCOMING and OUTGOING Internet communications from and to Vonage devices and servers.

RTP (Voice) Traffic: Ports 10000-20000 UDP. When a call is made, a random port between 10000 and 20000 is used for RTP (Voice) traffic. If any of these ports are blocked, you may experience one way or no audio.

Posts: 3 · New Forum Member Joined: Feb 13, 2007 Posts: 3

Thank you!!! I'll see how this works out!!! thanks again!