Static with D-Link Vta-VR

Posts: 3 · New Forum Member Joined: Oct 20, 2006 Posts: 3

I have just set up Vonage this week and transferred my number over. But, now that I have connected all of the house phones I get static on the lines. If I connect only one phone directly to the box it is a clean line. I didn't have any static when I had Verizon before switching.

I am connect from: Internet (Comcast) -- Linksys Wireless router WRT54G -- Vonage -- to RJ11 in the wall. The Vonage box is about 4 feet from the cable modem and router.

I called tech support and was on the phone off and on for about 2 hours but we couldn't get rid of the static. Although, when he did remove the static I lost the ringing and the caller ID so we eventually changed it back.

Any ideas?????

Speed test statistics
---------------------
Download speed: 6342304 bps
Upload speed: 359144 bps
Quality of service: 99 %
Download test type: socket
Upload test type: socket
Maximum download pause: 16 ms
Average download pause: 14 ms
Minimum round trip time to server: 25 ms
Average round trip time to server: 69 ms

Voip test statistics
--------------------
Jitter: you --> server: - ms
Jitter: server --> you: - ms
Packet loss: you --> server: - %
Packet loss: server --> you: 0.0 %
Packet discards: 0.0 %
Packets out of order: 100.0 %
Number of supported Voip lines: 6
Estimated MOS score: --

Posts: 3 · New Forum Member Joined: Oct 20, 2006 Posts: 3

After getting to the rat's nest of wiring I found a bad line in the basement. Luckily it was for a couple of jacks that I don't use.