Search found 12 matches

Well,

My alarm company tested the system and reported that they were able to access the panel. They will be sending test signals to confirm.

Dave L, outerfire: Thansk for ALL your help... This i ...

OK... I found the blue white pair from the office and pulled it off the punch block. Then I spliced it (had to due to short cable run) to the blue white wires in the phone block feeding the alarm pane ...

Luckily the guy who installed the telephone wires has labeled them right next to the punch block.

So, what you are saying is that I remove the blue white pair labeled living room (my office) from t ...

THis test seems to be an offshoot of the visualware speedtest at

http://myspeed.visualware.com/servers/ord.html. Here are my results..

Speed test statistics
---------------------
Download sp ...

THanks Dave

So, by disconnecting the blue/white in the phone jack and connecting the green/white, I am sending the dial tone through the house via the green / white pair. Then, by connecting the ...

Thanks to Dave and outerfire I am in business...!!! I have DSL and dial tone separated and distributed ...

The cordless phone has been moved to its permanent location a,d my dish network players ar ...

THANKS!!!!

I can't wait to try this ... it is late right now.... tomorrow I will try... and will post the results...

Thanks !

Now I get it (I think)...

I will disconnect the blue white @ the NIU outside. I will the connect the orange / white in its place. This should bring in the DSL to all jacks. All of the j ...

Hi.

I asked the question is the alarm forum and got some great advice but I am still not clear what to do. I was advised to post here since it involves more than alarm..

I have:

1. Verizon Dr ...

Yes, that will distribute the vonage dial tone to all of your phone jacks, but... The instructions are correct, as far as they go, but they ignore the fact that the blue/white pair from outside is d ...