Search found 7 matches

I set up the system with static IP yesterday, it then worked fine until about 7 pm last night when it crashed. I then went to v-configure as suggested and set it back to DHCP. This worked and now I ...

I again copied ( I had to go back to the Motorola so i could do my work during the day) all the information from the Motorola (DNS, IP, subnet...) into the V-Portal and hooked it up as such:

Westel ...

"If this fails, write Down the Status of the DLInk - WAN side
IP, Gateway and DNS. Manually assign these to the VPORTAL WAN side and see if this works." I have not seen how to manually assign these i ...

I have looked at the DLink configuration and tried to duplicate it, but without success in connecting the VPortal to the Westell. However, since the Dlink is after the Motorola, wouldn't the Motorola ...

Yes, I just read the comment from the 'Windows Control Panel/Internet options/Network Connections/Local area connection/Support' that said "Assigned by DHCP" I assume this means the PC accepts the IP ...

Yes, my computer will connect directly to the Westell with DHCP assigned by the PC.

I do not get any voice or internet connection when the new V-Portal is between the Westell and PC. By the way, ...

My problems start when I try to replace my VT1005 with the new V-Portal. I can not get it to connect to the internet following the same sequence.

1. Tampa Fl
2. Verizon DSL
3. 3 Mbps/768 Kbps
4 ...