Search found 9 matches

how do you know if you are using a two-conductor phone cord?

Look at the plug on either end of the phone cord. If the bottom of the plug has two copper lines, it's two-conductor. If there are fou ...

can you tell me the exact steps you took. i'm also having problems sending with my HP 6110.

As I mentioned... two-conductor phone cord from router to 6110. Vonage tech support changed the packet s ...

With the assistance of Vonage tech support, I have successfully configured my fax machine. Originally I could receive but not send faxes. After about 60 minutes on the phone with the rep I think it' ...

I am reading the instruction on wiring for Vonage as follows:

Once you've opened your side of the NIU, you'll see one or more sets of screw terminals inside. Each will have a short piece of telep ...

welcome aboard. I had the same problem with my line 2 port and it drove me nuts. The WAF (wife acceptance factor) was severely tested, as well.

I spent HOURS on the phone with Vonage tech support ...

My main Vonage line is set to Forward/SimulRing on both the regular Vonage phone and to another landline for 30 seconds.

This works fine on the main line and previously my Virtual number follow ...

A recent problem has cropped up with my call forwarding and SimulRing feature. I have a primary US Vonage phone number plus a UK Virtual number that rings on my regular Vonage line.

Previously if ...

I have a Uniden Tru8885 that I have been using for about 2 years. I recently upgraded to a Uniden True8866 for the two line feature. The 8885 has a built-in answering machine and the message light wil ...

Ms. Daisy dials your number (presumably a local call for her). Your number forwards to the second line(at your expense, which is zero if forwarding to another Vonage line).

Hope this helps.

I h ...