Search found 10 matches

This is so frustrating.

This time no red light, just slow green. This happened both with phone line connected and disconnected.

Again: restore to default > restart > power cycle

Here' ...

So to verify, I need to repeat the last step I took (which got me that IP) and follow the directions you posted?

Red light came back on, blinking fairly rapidly.
WAN Connected
IP is displayed
Unable to browse

http://i5.photobucket.com/albums/y171/Revoldo/sshot2.jpg

I'm gonna try this one more time.

I'm going in to the settings > restore to default > restart

I will unplug everything for 10 minutes.

Restart the cable modem and then, the vonage devic ...

Earlier, when I did the same thing...

The red light came on and it showed this...

http://i5.photobucket.com/albums/y171/Revoldo/sshot.jpg

I did the restore to default > restart > power cycle...

Power light only blinked green (slow). I could not browse.

And this is what the status showed.

http://i5.photobucket.com/albums/ ...

I did a "restore to default settings" ... then went back in and hit "restart". Power cycled, and the red light came back on.

But under status, my WAN was connected and it did show an IP. I did che ...

Please remember that my RED light is no longer coming on.

I will go back into device config... restore to default... make sure DHCP is on and restart device.

I will go back to device config, go ...

OK, After searching through the forums I tried several thing.

I disconnected the cable modem and had my vonage device connected to my PC.

Vonage > PC

Typed 192.168.15.1 in my browser for ...

Hello,

I've had my Vonage for about 2 years using the same hardware.

I am in Okinawa, Japan and use the following:

ISP: Mediatti Broadband (Cable)
Modem: Scientific Atlanta DPC2100
Vonage ...