Search found 16 matches

Good luck trying to figure out what happened. Same thing happened to me. Mine worked for 4 days then stopped. About 2 weeks later it started working again. This time it worked for about 2 months then ...

Thank you very much for the advice but that is a little beyond the lengths I want to go on this thing right now. I am probably going to just buy a new cordless with multiple handsets.

PhoneEar,

thanks for the reply. I have a line tester. Currently when I plug it into a wall jack I get nothing. If there is no power going to the inside wires should I still be getting a light? If ...

Thanks for the reply. I did disconnect from the telco, then I plugged the linksys into the wall and that is when it worked for 3 days. I'll see if I can find the testing kit at Radio Shack. Not quite ...

My inside wiring worked for 3 days, then stopped. That was two weeks ago. Without doing anything else, I plugged it in again this morning and it worked for about 10 minutes, then no dial tone again. C ...

Thank you. Yes, that does help explain things. I suppose it could also be the jack closest to the computer that is bad. Although I did try running a long cable to another jack and it did not work. I' ...

Same here. It would be next to impossible to follow all the different wires so I won't even bother.

Thanks for the reply. We didn't have any rain or storms. It just stopped. Sounds like it happened about the same time yours did. Mine went out 27 March. That's why I was wondering about the firmware. ...

I followed Vonage's instructions and disconnected from the telco and everything worked fine...for 3 days. Now, no more dialtones unless I am hooked directly into the router. It is narrowed down to e ...

You can use two routers. My Vonage came with the free Linksys router but I already had a D Link wirless, which I need. So, my wireless is only functioning as an access point/switch now. Routing, NAT, ...