Search found 14 matches

I'm using a wireless Linksys router/AP. It seems fine to me, though don't expect to connect your Vonage box wirelessly to the router -- it should be an ethernet cable connection.

Robbo123,

Thanks very much for the advice. I'm fairly familiar with the set-up of my Linksys router and could not find anywhere that allow me to set any parameters for packet size. I've emailed my ...

Any ideas why I would have 25% PL on my first hop and then between 92% and 60% all the rest of the way -- never lower than 60%? Seems off the chart bad compared to what you suggest. But my service is ...

Thanks for the great instructions!

I've had "iffy" results from the voicemail.

Also, I've taken to using the forwarding function, but it doesn't forward consistantly after the same amount of time (which I've set in the dashboard). ...

Thanks much for the detective work!

What feature are you describing? Your name on people's phones when you call them using Vonage or their name on your caller ID? I was getting phone numbers already, if not names.

Anyone else done this?

Why mess with the settings? Were you not getting good voice quality?

I have both and hadn't noticed any problems, but then again my voice quality isn't what I'd like it to be.

Let me know what y ...

Did you say you are using 802.11 to connect the Vonage box to your network? It may be a reception issue. If so, you should try moving the antennas around on the router or access point. Also, power ca ...