| Author |
Message |
| Topic: Rebate problem |
dustyc
Replies: 1
Views: 1103
|
Forum: Vonage Forum Archive
Posted: Sat Mar 19, 2005 1:09 pm Subject: I have an error for my $50 rebate on my phone adapter that says invalid account number. |
| I have an error for my $50 rebate on my phone adapter that says invalid account number. On the web-site it says that i will get a postcard in the mail with information for resubmitting which i haven' ... |
| Topic: Dead air at the begining of a call |
dustyc
Replies: 4
Views: 2442
|
Forum: Vonage Forum Archive
Posted: Mon Jan 17, 2005 5:30 pm Subject: Just wanted to thank everyone for the help, looks like replacing my old modem (shark |
| Just wanted to thank everyone for the help, looks like replacing my old modem (shark fin) with a new motorola SB5100 was the trick. |
| Topic: New home with Cat5e telephone runs can't get dialtone |
dustyc
Replies: 16
Views: 6985
|
Forum: Hard Wiring - Installation
Posted: Mon Jan 17, 2005 10:46 am Subject: Make sure they also test from the block to the RJ-11 plug that would connect to the |
Make sure they also test from the block to the RJ-11 plug that would connect to the phone port on your ATA.
I would also disconnect the feeds to the outside, just pull them straight back out of the ... |
| Topic: New home with Cat5e telephone runs can't get dialtone |
dustyc
Replies: 16
Views: 6985
|
Forum: Hard Wiring - Installation
Posted: Sun Jan 16, 2005 7:34 pm Subject: Unless you've already done so make sure that you punch solid copper, not stranded |
| Unless you've already done so make sure that you punch solid copper, not stranded to the 1x9 Bridged Telephone Board. Stranded wire will not get a good connection at all with a 110 block. |
| Topic: New home with Cat5e telephone runs can't get dialtone |
dustyc
Replies: 16
Views: 6985
|
Forum: Hard Wiring - Installation
Posted: Sun Jan 16, 2005 11:35 am Subject: If they "toned" the cable did they just verify the cable, or did they tone the cable |
They also toned the lines to verify the pairs were ok on all the jacks. Any ideas?
If they "toned" the cable did they just verify the cable, or did they tone the cable then verify how the pairs ... |
| Topic: Background Noise Victims look here |
dustyc
Replies: 88
Views: 37170
|
Forum: Vonage Forum Archive
Posted: Thu Jan 13, 2005 6:51 pm Subject: Just make sure you don't short out any of the RJ-45 ports! |
| Just make sure you don't short out any of the RJ-45 ports! |
| Topic: Background Noise Victims look here |
dustyc
Replies: 88
Views: 37170
|
Forum: Vonage Forum Archive
Posted: Thu Jan 13, 2005 6:14 pm Subject: Just crimped on a RJ-11 with pins 3 and 4 shorted and ALL noise is now gone. Hopefully |
| Just crimped on a RJ-11 with pins 3 and 4 shorted and ALL noise is now gone. Hopefully it doesn't mess something else up though. Thanks for the post! |
| Topic: Modem Replacement question |
dustyc
Replies: 0
Views: 2366
|
Forum: The Cafeteria - Any Non Vonage Topic
Posted: Wed Jan 12, 2005 11:28 pm Subject: Today i went out and purchased a Motorola SB5100 to swap out with my old Home Connect |
| Today i went out and purchased a Motorola SB5100 to swap out with my old Home Connect Shark Fin. After changing the MAC addresses around with my provider my connection was up in no time. I wish i ran ... |
| Topic: Dead air at the begining of a call |
dustyc
Replies: 4
Views: 2442
|
Forum: Vonage Forum Archive
Posted: Tue Jan 11, 2005 10:10 pm Subject: This one was the worse out of the 12 or so i did.
MOS Analysis from You TO Boston |
This one was the worse out of the 12 or so i did.
MOS Analysis from You TO Boston
Media Quality MOS 4.0 / 5.0
(Best with G.711 is 4.4)
Degradation Sources
Codec 0.57 57.9%
... |
| Topic: Dead air at the begining of a call |
dustyc
Replies: 4
Views: 2442
|
Forum: Vonage Forum Archive
Posted: Tue Jan 11, 2005 8:00 pm Subject: When I make or receive a call it takes anywhere from 3 to 10 seconds for the person |
| When I make or receive a call it takes anywhere from 3 to 10 seconds for the person on the other end to hear me. Just dead air for them, but i can here them just fine. I’m wondering if this has happ ... |
| |