Search found 66 matches

Here's my physical config:

Internet -> Moto -> D-Link router -> PC1,PC2

From Vonage support:

In regards to your question about QoS and NAT, if you have disabled NAT, you are disabling the feature of the device to function as a router which will disable QoS.

Eh?

- ...

I would like to setup my Motorola VT1000 in front of my D-Link 714P+ router. I have read that when NAT is disabled on VT1000,

I do this now. I have a Motorola VT1005 and a D-Link DI-624. Here ar ...

casechopper, you don't mention whether it's you who hears bad voice or the person at the other end of the call.

If it's the other person, that would suggest the Moto's QOS queuing is not working ...

zdoe, be careful. The PCs are doing outbound POP and SMTP. Port forwarding on the Moto or on any other would have no effect. I need more info to solve this. Do other typical 'outbound' application ...

7- and 10-digit dialing work in area code 612. delay at the end of dialing 7 digits is about 6-7 seconds. THANKS, VONAGE! Now, if we could only do something about inbound QOS...

7- and 10-digit dialing work in area code 612. delay at the end of dialing 7 digits is about 6-7 seconds. THANKS, VONAGE! Now, if we could only do something about inbound QOS...

This sounds like ethernet autosense problems (maybe). polivieri, it's possible the Linksys and the Moto are not autosensing speed and duplex correctly with each other and this is causing the Linksys ...

I have had zero VPN problems since my Moto was upgraded to software version 1.16d. It's now at 1.16e. 1.16d had some VPN fixes. I use both Microsoft Windows 2000's PPTP and IPSec via the Cisco VPN ...

How do you check that?

I plugged a switch into the PC port of the Moto and then plugged 2 PCs into the switch. Both PCs worked. But, the Moto had to be in NAT mode because my ISP (RoadRunner) wil ...