Search found 13 matches

Now it's getting wierd.

If I set IPCop to run with 192 MB RAM, faxes fail.
With 64MB, they work. Less RAM yields better results?

Now I'm trying to tweak traffic shaping settings to give UDP po ...

One interesting tidbit, though I don't know if it's relevant.

The fax always fails at 36 seconds, and the following happens:

- Sending fax calls outbound.
- Receiving fax picks up phone and bro ...

I have a Vonage fax line and a multifunction fax machine. This is a vonage fax line - not a voice line I am trying to use for faxes.

When my network is configured as follows, fax works:
Cable Mod ...

Almost forgot. I've already done the obvious. ECM is off and my fax send speed is set to 9600bps.

I was hoping someone could give me a clue as to a problem.

I have a Vonage fax line, and I can receive faxes, but I cannot send.

Every fax I send has the same result:
36 second communication ti ...

Thanks all,

After working with the seller, Vonage, and a few service calls, the device is hooked up and working under my account.

It turns out that the seller did cancel - the error was on Vonag ...

Sorry, bad joke.

The Weekly World News is a newspaper that specializes in the news noone else dares print. Bat-boy. Bigfoot. Alien backs clinton. Conspiracies.

You know, the real investigati ...

I knew about the bill thing and have an e-mail from him, from before I bid, that he didn't owe vonage any cash. Now, if the account is indeed active, that status could have changed (I didn't anticipa ...

Thank you for the advice. I anticipated that I might not be able to activate the device, but it was only $6.50, and even if I don't use it as an ATA, it's better than my current piece-of-crap SMC rou ...

I just bought a used ATA (A Linksys RT31P2). I plugged it in and started playing with it, only to discover it's active! I would like to use the linksys so I have a multi-port lined router and ATA al ...