Search found 24 matches

FYI, the beta Linksys firmware 1.00.15(and 1.00.13) DOES FIX(finally) the Vonage issue with the firewall treating it as a DOS attack(as I mentioned in my post above).

However, for it to work, afte ...

What version of the WRT54G do you have? If it a V5, make sure you load the newest firmware, as it supposedly fixed some issues.

FYI, linksys has a beta firmware, version 1.00.12 that they are sending to people with QOS issues(it's not on the website yet).

I have installed it but it doesn't fix the SPI issue with it treating ...

New firmware released(1.01.14) that sems to address the voip issues people had.

1. Fixed connectivity with PAP2 device.
2. Fixed PPPoE connectivity with Belgacom in Europe.
3. Fixed the help file ...

Try disabling SPI(could be labeled as firewall) within your router. Sometimes SPI tends to think the data stream is a DOS attack and will drop packets to try to block it.

If your router has a DOS a ...

To get rid of the choppiness when your Vonage is behind the GX router, disable its SPI firewall. The firewall slows the data down to the point where some of it gets dropped. This is because the proces ...

The VT1005's setup page is 192.168.102.1

Ok, so I got a voice message a couple weeks ago and got the stuttering dialtone, when first picking up the receiver(Motorola 1005 ATA). I went in and deleted the VM. BUT, the stuttering tone still hap ...

I've tried everything, it's just a crappy little router.

It hangs, where only a hard reset will make it work, does this regularly, and i have the latest firmware. Netgear service is bad enough to m ...

A couple things to try, for those with issues:

1. Try to assign a static IP address to the VT1005, if it is behind a router. With my netgear, a "reserver" the same IP from DHCP, so it get the same ...