 |
 | Vonage Forum Menu |
| | |
| Vonage Forums |
|
|
| | | |
| Vonage In The News |
| | |
| Vonage User Reviews |
| | |
| |
Vonage You're pretty far off on those ports. Let's take a step back. First, you don't need
You're pretty far off on those ports. Let's take a step back. First, you don't need to port forward anything for Vonage, all communications are initiated from your Vonage device, so there is no need for forwarding anything.
As far as QoS, again, all you need to do is setup outbound QoS...inbound (from the Internet) will do nothing for you. I don't know where you're performing the QoS or what device you're doing it on, but you should apply QoS to the following:
UDP 5060 and 5061 (SIP traffic. Some devices use 5060, some use 5061)
UDP 10000-20000 (RTP audio)
RTP audio should be guaranteed 90Kbps and SIP about 20Kbps (that's probably even too much, but you can start there). When I say "guaranteed", that means under conditions of congestion. That means your QOS router must have accurate numbers for what your upload speed is on your broadband circuit. If it thinks your upload speed is 10MBps, but it's actually 384Kbps, QoS will never kick in because it won't think the circuit is overloaded.
As far as load-balancing routers and VoIP. What you heard was not at all true. That happens every day to all of us out on the Internet.
If you want to guarantee all your outbound VoIP traffic traverses one and only one circuit, you can do that but it depends on your setup. If you want to ensure your VoIP traffic exists only one of the two circuits, you're pretty much going to need a device that supports PBR (policy based routing).
Read The Full Thread: ''High level" tech question regarding QOS w/ Vonage
• Vonage phone device: Motorola VT2442
Router: Netgear FVS124G
Connection(s):
• Anyone have port info?
• Usually the Vonage device will use 5060, 5061, and 10k-20k for RTP. That's about
• TCP or UDP? Especially the 5000 range ports.
• Streaming audio = UDP
• I don't think these are all of the ports used by vonage.
I set my firewall to
• One issue might be that you set TCP/UDP 10050-10150
Vonage uses 10000-20000.
EzCo posted "You're pretty far off on those ports. Let's take a step back. First, you don't need" on 11/07/2007 |
|
|
| |
| Vonage Service Plans |
| | |
| Vonage VoIP Members |
|
 Members
 New mknjmb
 New Today 0
 Yesterday 6
 Total 55096
 Who Is On Site
 Visitors 235
 Members 0
 Total 235
Vonage VoIP Forum Members:
Login Here
Not a Member? You can Register Here
As a registered member you will have access to the VoIP Speed Test, Vonage Service Announcements and post comments in the
Vonage VoIP Forums | | | |
| Vonage Stock Price |
|
Value: 1.16
Change:  -0.04
Up to 15 Minute Delay | | | |
| Site Search |
| | |
|
|
Vonage VoIP Phone Service is redefining communications by offering consumers
& small business VoIP Internet phones, an affordable alternative to traditional phone service.
The Vonage VoIP Forum Generated This Page In: 0.31 Seconds and 225 Pages In The Last 60 Seconds
The Vonage VoIP Forum
|
