 |
 | Vonage Forum Menu |
| | |
| Vonage Forums |
|
|
| | | |
| Vonage In The News |
| | |
| Vonage User Reviews |
| | |
| |
Vonage No, you really have to make sure you enable shaping because the key point of QoS
No, you really have to make sure you enable shaping because the key point of QoS (at least on real routers) is that it does not engage unless there is congestion. It's not possible to configre the router to enagage QoS just because there is the presence of traffic you would like to prioritize.
You'll definitely need to shape on the ethernet of the 2501 (connected to cable). However, to answer if you'll need to shape on the 2507, I need to know the actual speed of the circuit b/w the two 2500s. Are these just two 2500s stacked in your house with a DTE/DCE v.35 (or other) connection b/w them, or do you actually have a T1 or fractional T1 from a carrier b/w them? The short answer on that is basically if you have a sub-rate circuit between them (below T1), you'll need to shape to the speed of your circuit. If you have DCE/DTE, just set your clockrate on the DCE side to the max (I believe 2Mbps on a 2500) and you're fine, no shaping needed.
You can, however, put the same QoS policy on both routers. Egress of the serial on the 2507 and egress of the ethernet on the 2500. The one on the 2507 may just not include a shaping component.
I haven't followed what features are available on a 2500 for about six years, so make sure they support LLC before planning on this implementation.
Read The Full Thread: Cisco VOIP QoS for Vonage
• Hi everyone,
I'm posting this in hopes that it will help others configure
• How do you tell whether or not the QoS is actually working? Simply enter the command
• Just to let you know this post was a huge help to me.
Thank you very much for taking
• Good stuff. That's a pretty standard config, but let me share a slightly different
• To Celeron (or EzCo),
Just curios, I am getting ready to take my ccna so all
• Doesn't matter what is behind the Cisco, it's just going to (outbound) priority
• So there's no way to do this without trying to match your upload speed? Is there
• They are stacked and connected with two DTE/DCE cables right now. I put your example
• Class-map: class-default (match-any)
905660 packets, 369453629 bytes
EzCo posted "No, you really have to make sure you enable shaping because the key point of QoS" on 05/07/2006 |
|
|
| |
| Vonage Service Plans |
| | |
| Vonage VoIP Members |
|
 Members
 New modspam
 New Today 2
 Yesterday 11
 Total 55109
 Who Is On Site
 Visitors 138
 Members 0
 Total 138
Vonage VoIP Forum Members:
Login Here
Not a Member? You can Register Here
As a registered member you will have access to the VoIP Speed Test, Vonage Service Announcements and post comments in the
Vonage VoIP Forums | | | |
| Vonage Stock Price |
|
Value: 1.16
Change:  0.00
Up to 15 Minute Delay | | | |
| Site Search |
| | |
|
|
Vonage VoIP Phone Service is redefining communications by offering consumers
& small business VoIP Internet phones, an affordable alternative to traditional phone service.
The Vonage VoIP Forum Generated This Page In: 0.32 Seconds and 158 Pages In The Last 60 Seconds
The Vonage VoIP Forum
|
