 |
 | Vonage Forum Menu |
| | |
| Vonage Forums |
|
|
| | | |
| Vonage In The News |
| | |
| Vonage User Reviews |
| | |
| |
Vonage Is it possible to change the VT2442 to be used as a switch and not a router? I know
Is it possible to change the VT2442 to be used as a switch and not a router? I know a little about networking and have tried what I know to make this work. I have also searched the forum for answers and any of the methods discribed has not worked for me.
I have basically ran out of room on my Linksys router and need one more port to run my Printer on the network. Maybe I'm not seeing it but a fresh voice will hopefully help me. My understanding is that you need to run the WAN cable into one of the LAN ports and turn off DHCP and assign an IP address to the router. However, doing this causes the Phone to not work, because it uses the WAN port for the VOIP. If any of this is wrong, please let me know.
My setup is: Internet > Linksys WRT54G > Motorola VT2442. I have the Linksys as the DHCP with two computers connected in Ports 1 and 2, the VT2442 in Port 3 and Port 4 goes out the switch that controls the network for the house with other computers, Xbox 360, Tivo, etc connected. The Linksys and VT2442 along with two computers and printer are in my Office with the switch located in my closet in my Master bedroom going out to the rest of the house, so connecting the printer to the switch will not work.
Any help would be greatly appreciated!
-Dave
Read The Full Thread: Setup of VT2442 to Operate as a Switch
• try plugging an ethernet cable from one of the lan ports of the linksys into one
• It sounds as if you had it right. However, you should not need to assign an address
• I field tested the VT2442, and one of my negative comments about it was that there
• Other people have made bridge mode work with the VT2442. Start near the bottom
• Hmmm. That's absolutely the normal way to set up bridge mode on any router. When
• Ok I have tried it the way Steve48 mentioned.....and it has worked! This was the
• Yeah, I didn't even think about connecting the VT2542's WAN port to one of its own
• http://vonage.nmhoy.net/tworouters.html
What you are trying to do is
• Nate,
Your diagrams are great. When the VT2542 starts showing up in the hands
Dmills21 posted "Is it possible to change the VT2442 to be used as a switch and not a router? I know" on 03/27/2007 |
|
|
| |
| Vonage Service Plans |
| | |
| Vonage VoIP Members |
|
 Members
 New clover
 New Today 10
 Yesterday 21
 Total 51453
 Who Is On Site
 Visitors 336
 Members 8
 Total 344
Vonage VoIP Forum Members:
Login Here
Not a Member? You can Register Here
As a registered member you will have access to the VoIP Speed Test, Vonage Service Announcements and post comments in the
Vonage VoIP Forums | | | |
| Vonage Stock Price |
|
Value: 0.62
Change:  -0.01
Up to 15 Minute Delay | | | |
| Site Search |
| | |
|
|
Vonage VoIP Phone Service is redefining communications by offering consumers
& small business VoIP Internet phones, an affordable alternative to traditional phone service.
The Vonage VoIP Forum Generated This Page In: 0.42 Seconds and 1919 Pages In The Last 60 Seconds
The Vonage VoIP Forum
|
