 |
 | Vonage Forum Menu |
| | |
| Vonage Forums |
|
|
| | | |
| Vonage In The News |
| | |
| Vonage Customer Reviews |
| | |
| |
Vonage Hey BerettaMan,
I was reading your post and I have a similar setup, but different
Hey BerettaMan,
I was reading your post and I have a similar setup, but different issue. I have TimeWarner Cable(thru Earthlink)+CPI+Vonage and we've been having dropped calls since installation, but they've been getting more frequent..2-3 a day. We were getting dropped calls before CPI tapped ito the phone jack. I also have a 2.4GHz cordless phone.
I have a Linksys WRTP54G wireless and PhoneJack#1 is plugged into the wall unit to light my home telephones(demarc box is properly unplugged). CPI is monitoring my line from the same walljack the router is plugged into.
The test results seem fine, but this seems to happen during the daylight hours. Any ideas(other than test during the day and see if the results vary to the slow extreme)?
Test results from testyour Voip:
Test Details 8:pm 4/26/2006
MOS Analysis From You TO Boston
Media Quality MOS 4.2 / 5.0
(Best with G.711 is 4.4)
Degradation Sources
Codec 0.57 70.7%
Latency 0.00 0.0%
Packet Discards 0.24 29.3%
Packet Loss 0.00 0.0%
Codec G.711 (PCM at 64kbps,
20ms RTP payload,
80kbps IP BW)
Round-Trip
Latency 110 ms
Packet Discards 1.2%
Packet Loss 0.0%
Loss Periods Min: 20 ms
Avg: 20 ms
Max: 60 ms
Random Loss
Jitter Min: 0 ms
Avg: 2 ms
Max: 32 ms
Signaling Quality Post-Dial Delay 80 ms
Call Setup Time 90 ms
Media Delay 230 ms
MOS Analysis FROM Boston To You
Media Quality MOS 4.4 / 5.0
(Best with G.711 is 4.4)
Degradation Sources
Codec 0.57 96.8%
Latency 0.00 0.0%
Packet Discards 0.02 3.2%
Packet Loss 0.00 0.0%
Codec G.711 (PCM at 64kbps,
20ms RTP payload,
80kbps IP BW)
Round-Trip
Latency 110 ms
Packet Discards 0.1%
Packet Loss 0.0%
Loss Periods Min: 20 ms
Avg: 20 ms
Max: 20 ms
Random Loss
Jitter Min: 0 ms
Avg: 0 ms
Max: 30 ms
Signaling Quality Post-Pickup Delay 126 ms
Call Setup Time 115 ms
Media Delay 160 ms
Read The Full Thread: WRTP54G static only on ALARM system
• Ah, that explains the firmware issue. The WRTP54G and the RTP300 are essentially
• The structured wiring:
My house is roughly 2 years old. The method used to wire
• Okay, So I've searched and read through the posts, but can't find enough info to
• Are you sure that the test conditions are exactly the same? How did you connect
• I can't think of what wasn't the same.
The steps were this:
We disconnected
• One major correction. The neighbor's adapter is a RTP300. NOT a PAP2.
• It sounds like a standard modern setup. And it sounds like you know what you're
• Thanks for the vote of confidence.
I bought one of those line testers at Radio
• Got the RMAd unit. And got the new device registered through customer support
joephil posted "Hey BerettaMan,
I was reading your post and I have a similar setup, but different" on 04/26/2006 |
|
|
| |
| Vonage Service Plans |
| | |
| Vonage VoIP Members |
|
 Members
 New JODI
 New Today 3
 Yesterday 5
 Total 64287
 Who Is On Site
 Visitors 162
 Members 0
 Total 162
Vonage VoIP Forum Members:
Login Here
Not a Member? You can Register Here
As a registered member you will have access to the VoIP Speed Test, Vonage Service Announcements and post comments in the
Vonage VoIP Forums | | | |
| Vonage Stock Price |
|
Value: 1.70
Change:  -0.03
Up to 15 Minute Delay | | | |
| Site Search |
| | |
|
|
Vonage VoIP Phone Service is redefining communications by offering consumers
& small business VoIP Internet phones, an affordable alternative to traditional phone service.
The Vonage VoIP Forum Generated This Page In: 0.39 Seconds and 244 Pages In The Last 60 Seconds
The Vonage VoIP Forum
|
