 |
 | Vonage Forum Menu |
| | |
| Vonage Forums |
|
|
| | | |
| Vonage In The News |
| | |
| Vonage Customer Reviews |
| | |
| |
Vonage For those who have a router and have connected their VT1005 THROUGH the router,
For those who have a router and have connected their VT1005 THROUGH the router, rather than AHEAD of it, you have to connect an ethernet cable directly from your PC to the PC port in the back of the VT1005 in order to see the Adapter administration screens, or at least that's what I had to do. I just disconnected the PC cable from it's router port and connected it to the adapter.
The adapter page you need is http://192.168.102.1/bascfg.html. On that screen, click the radio button for Obtain IP Address Dynamically. You will get a pop-up asking to reboot the unit. I said OK, gave it a few minutes, and got my phone back.
I found that once the adapter got into the 4-blinks-pause-4-blinks state it stopped responding to the browser and I had to pull the power for a second to cause it to restart and let me get a second response. In retrospect I could probably have just disconnected it from the internet while I did this, but I didn't think to try that at the time.
Thanks VERY much to the folks who figured out what was wrong and how to fix it. I would never have figured it out, and it doesn't seem like Vonage tech support is doing too well either. It's a shame that they couldn't have at least told me what needed to be done, or, better yet, have corrected their mistake. I was without phone service for a full day over this. That's just inexcusable.
Read The Full Thread: What happened to my post about the service interruption?
• I never had the problem since I always used DHCP, but a friend had a static IP assigned,
• About 6 hours ago I posted a message about the second major Vonage outage this week,
• Why is there absolutely no reference to this outage (which tech support also confirmed
• Finally another voice in the forest!
My original post was quite long, and
• It did not adhere to the Forum Rules (title in all caps).
• What happened to my post about the service interruption?
Yes it may have been
• It did not adhere to the Forum Rules (title in all caps).
I restate: It did not
• Are you guys by any chance using the Motorola 1005? If so check to make sure that
• All VT1005's were sent a firmware upgrade today that caused a NDT (no dial tone)
• Login to the VT1005 in the admin page and do a reset. If I remember correctly it's
jackcree posted "For those who have a router and have connected their VT1005 THROUGH the router," on 08/26/2006 |
|
|
| |
| Vonage Service Plans |
| | |
| Vonage VoIP Members |
|
 Members
 New JODI
 New Today 3
 Yesterday 5
 Total 64287
 Who Is On Site
 Visitors 148
 Members 0
 Total 148
Vonage VoIP Forum Members:
Login Here
Not a Member? You can Register Here
As a registered member you will have access to the VoIP Speed Test, Vonage Service Announcements and post comments in the
Vonage VoIP Forums | | | |
| Vonage Stock Price |
|
Value: 1.70
Change:  -0.03
Up to 15 Minute Delay | | | |
| Site Search |
| | |
|
|
Vonage VoIP Phone Service is redefining communications by offering consumers
& small business VoIP Internet phones, an affordable alternative to traditional phone service.
The Vonage VoIP Forum Generated This Page In: 0.34 Seconds and 239 Pages In The Last 60 Seconds
The Vonage VoIP Forum
|
